Spectra UL633-14 User Manual download pdf (Page 11)

Usebutton 1 or 2(PlusorMinus)tosetthedesireddigit.

Thelaserwillself-leveltotherequiredgradepositionafterconrmingthegradechangewithbutton4.

Note: Thebubblesymbolsatthelaser’sLCDwillashuntilthelaserhasbeenself-leveledtotherequested

grade position.

Using the Rotation mode

Repeatedlypressingthebutton4togglesthrough0,80,200,600,900rpmregardlessiftheunit

is in automatic or manual mode.

At0rpm,thebeamstopsautomaticallyclosetothe+Y-axiscenterposition(pipelayingover

the top).

Whensetuphorizontallyin automatic orgrademode,usingbuttons5/8increases/decreases

rotorspeedfrom0to80andthenupto900rpmcontinuouslyin10rpmincrements.

Pointing mode

At0rpm,buttons6/7movethebeamtotheleft/rightside.Whensetupverticallyat0rpm,button5/8 move

thebeamclockwise/counterclockwise.

Note: Press and hold button 4 for three seconds to change the unit from rotation mode (default) into scan mode.

Using the Scan mode

Press and hold button 4attheStandardDisplayforthreesecondstochangetheunitintoscan

mode.

Quickly press and release button 4totogglebetweenthepre-selectedscansizes5,15,45,90,

180degreesand0;regardlessiftheunitisinautomaticormanualmode.

Whenworkinginhorizontalautomaticmode,pressandholdbutton5/8toincrease/decreasethe

linesizein5degreesincrements.Pressandholdbutton 6/7movesthescanlinetotheright/leftdirection.

Whenusedinautomaticverticalmode,pressingandholdingbutton5/8movesthescanlinecounterclockwise/

clockwise.Whensetupvertical,pressingandholdingbutton6/7movesthescanlineintotheright/leftdirection

regardless if in automatic or manual mode.

Note: Press and hold button 4 for three seconds to change the unit back to rotation mode (default) mode.

Manual mode

Pressing and releasing button 3attheStandardDisplayactivates/deactivates

the manual mode regardless if set up horizontal or vertical.

Manual mode is indicated by horizontal lines next to the axes symbols.An

additionalbubblehelpstoadjustthelaseronthecrossaxiswhensetupvertical.

InManualmode(horizontal),theY-axiscanbeslopedbypressingtheUp-(5)andDown-Arrow-(8) buttons on

thelaser‘skeypadortheremotecontrol.Additionally,theX-axiscanbeslopedbypressingtheLeft-(6) and

Right-(7)Arrow-buttonsonthelaserorremotecontrol.

Inverticalmode,theupanddownarrowbuttonsadjusttheZ-axisslope,andtheleftandrightarrowbuttons

alignthelaserbeamtotheright/leftside.

To resume automatic self-leveling mode, press the manual button again.

111560trimble_UL633_01_GB.indd 6 19.01.12 13:24

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

No comments

Spectra UL633-14 User Manual Page 11